Users Guide

Command Modes CONFIGURATION (conf-if-interface-slot/port)
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
ip igmp querier-timeout
Change the interval that must pass before a multicast router decides that there is no longer another multicast router that should be the
querier.
Syntax
ip igmp querier-timeout seconds
To return to the default value, use the no ip igmp querier-timeout command.
Parameters
seconds Enter the number of seconds the router must wait to become the new querier. The range
is from 60 to 300. The default is 125 seconds.
Defaults 125 seconds
Command Modes INTERFACE
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
ip igmp query-interval
Change the transmission frequency of IGMP general queries the Querier sends.
Syntax
ip igmp query-interval seconds
To return to the default values, use the no ip igmp query-interval command.
Parameters
seconds Enter the number of seconds between queries sent out. The range is from 1 to 18000.
The default is 60 seconds.
Defaults 60 seconds
524 Internet Group Management Protocol (IGMP)