Users Guide

Example (2
Summary)
Dell#show frrp 2 summary
Ring-ID State Mode Ctrl_Vlan Member_Vlans
-----------------------------------------------
2 Up Master 2 11-20, 25, 27-30
Dell#
Related Commands protocol frrp — enters the resilient ring protocol and designate a ring identication.
timer
Set the hello interval or dead interval for the Ring control packets.
Syntax
timer {hello-interval milliseconds}| {dead-interval milliseconds}
To remove the timer, use the no timer {hello-interval [milliseconds]}| {dead-interval
milliseconds} command.
Parameters
hello-interval
milliseconds
Enter the keyword hello-interval then the time, in milliseconds, to set the hello
interval of the control packets. The milliseconds must be entered in increments of 50
millisecond; for example, 50, 100, 150, and so on. If an invalid value is entered, an error
message is generated. The range is from 50 to 2000 ms. Default: 500 ms.
dead-interval
milliseconds
Enter the keyword dead-interval then the time, in milliseconds, to set the dead
interval of the control packets. The range is from 50 to 6000 ms. Default: 1500 ms.
NOTE: The congured dead interval must be at least three times the hello
interval.
Defaults
• 500 ms for hello-interval milliseconds
• 1500 ms for dead-intervalmilliseconds
Command Modes CONFIGURATION (conf-frrp)
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The hello interval command is the interval at which ring frames are generated from the primary interface of
the master node. The dead interval command is the time that elapses before a time-out occurs.
Force10 Resilient Ring Protocol (FRRP) 511