Users Guide

map allows the switch to operate as an FCoE-FC bridge between an FC SAN and an FCoE network. It provides
necessary parameters to FCoE-enabled servers and switches to log in to a SAN fabric. Use the fcoe-map
command to create an FCoE map.
On an FN IOM NPIV proxy gateway, an FCoE map is applied on fabric-facing FC ports and server-facing Ethernet
ports. Use the fabric command to apply an FCoE map on an FC port. Use the fcoe-map command to apply an
FCoE map on an Ethernet port.
After you apply an FCoE map on an FC interface, when the port is enabled (no shutdown), the NPIV proxy
gateway starts sending FIP multicast advertisements on behalf of the FC port to downstream servers to advertise
the availability of a new FCF port on the FCoE VLAN.
To remove an FCoE map from an FC interface, enter the no fabric map-name command in Interface
conguration mode.
Related Commands
fcoe-map — creates an FCoE map which contains the parameters used in the communication between servers
and a SAN fabric.
show fcoe-map — displays the Fibre Channel and FCoE conguration parameters in FCoE maps.
active-zoneset
Activate the zoneset.
Syntax
active-zoneset zoneset_name
To change to the default zone behavior, use the no active-zoneset zoneset_name command.
Parameters
zoneset_name Enter the zoneset name.
Command Modes FC FABRIC CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
9.1(1.0) Introduced on the S5000.
Example
Dell(conf)# fcoe-map default_full_fabric
Dell(conf-fcoe-default_full_fabric)# fc-fabric
Dell(conf-fmap-default_full_fabric-fcfabric)# active-zoneset zs1
Related Commands
show fc zoneset — displays the congured and active zoneset.
478 FC FLEXIO FPORT