Users Guide

Parameters
value Enter the priority list value. Separate priority values with a comma; specify a priority range
with a dash; for example, priority-list 3,5-7. The range is from 0 to 7.
Defaults none
Command Modes PRIORITY-GROUP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information By default:
• All 802.1p priorities are grouped in priority group 0.
• 100% of the port bandwidth is assigned to priority group 0. The complete bandwidth is equally assigned to
each priority class so that each class has 12 to 13%.
NOTE: Please note that Dell Networking does not recommended to use this command as it has been
deprecated in the current 9.4(0.0) release. A warning message appears when you try to run this
command indicating that you have to use the dcb-map commands in the future.
scheduler
Congure the method used to schedule priority trac in port queues.
Syntax
scheduler value
To remove the congured priority schedule, use the no scheduler command.
Parameters
value Enter schedule priority value. The valid values are:
• strict: strict-priority trac is serviced before any other queued trac.
• werr: weighted elastic round robin (werr) provides low-latency scheduling for priority
trac on port queues.
Defaults Weighted elastic round robin (WERR) scheduling is used to queue priority trac.
Command Modes POLICY-MAP-OUT-ETS
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
424 Data Center Bridging (DCB)