Users Guide

NOTE: When you recongure CAM allocation, use the nlbclusteracl
number command to change the number of NLB ARP entries. The range is from
0 to 2. The default value is 0. At the default value of 0, eight NLB ARP entries
are available for use. This platform supports upto 256 CAM entries. Select 1 to
congure 128 entries. Select 2 to congure 256 entries. Even though you can
perform CAM carving to allocate the maximum number of NLB entries, Dell
Networking recommends that you use a maximum of 64 NLB ARP entries.
vman-qos|vman-
dual-qos number
Enter the keyword vman-qos and then the number of FP blocks for VMAN QoS. The
range is from 0 to 6.
vman-dual-qos
number
Enter the keyword vman-dual-qos and then the number of FP blocks for VMAN dual
QoS. The range is from 0 to 4.
Ipv4pbr number Enter the keyword ipv4pbr and then the number of FP blocks for ipv4pbr ACL. The
range is from 0 to 8.
Openow number Enter the keyword openflow and then the number of FP blocks for open ow (multiples
of 4). The range is from 0 to 8.
fcoeacl number Enter the keyword fcoeacl and then the number of FP blocks for FCOE ACL. The
range is from 0 to 6.
Iscsioptacl number Enter the keyword iscsioptacl and then the number of FP blocks for iSCSI
optimization ACL. The range is from 0 to 2.
l2acl number
ipv4acl number
ipv6acl number,
ipv4qos number
l2qos number, l2pt
number ipmacacl
number ecfmacl
number [vman-qos
| vman--qos-dual
number | vman-
qos-dual-fp
number] ipv4pbr
number
Allocate space to each CAM region.
Enter the CAM prole name then the amount of CAM space to be allotted. The total
space allocated must equal 13. The range for ipv4acl is from 1 to 4. The ipv6acl range
must be a factor of 2.
The total space allocated must equal 13.
The range for ipv4acl is 1 to 4.
The ipv6acl range must be a factor of 2.
The vman-qos-dual-fp number must be entered as a multiple of 4.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Added the keyword nlbcluster ACL.
9.4.(0.0) Added support for PBR.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Save the new CAM settings to the startup-cong (write-mem or copy run start) then reload the system
for the new settings to take eect.
380 Content Addressable Memory (CAM)