Users Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The following describes the show ip bgp paths extcommunity command shown in the following example.
Field Description
Address Displays the internal address where the path attribute is stored.
Hash Displays the hash bucket where the path attribute is stored.
Refcount Displays the number of BGP routes using these extended communities.
Community Displays the extended community attributes in this BGP path.
Example
Dell#show ip bgp paths extcommunity
Total 1 Extended Communities
Address Hash Refcount Extended Community
0x41d57024 12272 1 RT:7:200 SoO:5:300 SoO:0.0.0.3:1285
Dell#
show ip bgp extcommunity-list
View information on all routes with Extended Community attributes.
Syntax
show ip bgp [ipv4 unicast] extcommunity-list [list name]
Parameters
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to view information only related to
ipv4 unicast routes.
list name Enter the extended community list name you wish to view. The range is 140 characters.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
To view the total number of COMMUNITY attributes found, use the show ip bgp summary command. The
text line above the route table states the number of COMMUNITY attributes found.
The show ip bgp community command without any parameters lists BGP routes with at least one BGP
community attribute and the output is the same as for the
show ip bgp command output.
Border Gateway Protocol IPv4 (BGPv4) 371