Users Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
CAUTION: Dell Networking OS recommends that you do not change the administrative distance of
internal routes. Changing the administrative distances may cause routing table inconsistencies.
The higher the administrative distance assigned to a route means that your condence in that route is low. Routes
assigned an administrative distance of 255 are not installed in the routing table. Routes from confederations are
treated as internal BGP routes.
show ip bgp dampened-paths
View BGP routes that are dampened (non-active).
Syntax
show ip bgp [ipv4 unicast] dampened-paths
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The following describes the show ip bgp damp command shown in the following example.
Field Description
Network Displays the network ID to which the route is dampened.
From Displays the IP address of the neighbor advertising the dampened route.
Reuse Displays the hour:minutes:seconds until the dampened route is available.
Path Lists all the ASs the dampened route passed through to reach the destination network.
Example
Dell>show ip bgp dampened-paths
BGP table version is 210708, local router ID is 63.114.8.2
Status codes: s suppressed, d damped, h history, * valid, > best
Path source: I - internal, a - aggregate, c - confed-external, r -
redistributed, n - network
Origin codes: i - IGP, e - EGP, ? - incomplete
Network From Reuse Path
Dell>
368 Border Gateway Protocol IPv4 (BGPv4)