Users Guide

show ip bgp cluster-list
View BGP neighbors in a specic cluster.
Syntax
show ip bgp [ipv4 unicast] cluster-list [cluster-id]
Parameters
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to view information only related to
ipv4 unicast routes.
cluster-id (OPTIONAL) Enter the cluster id in dotted decimal format. The range is 1 —
4294967295.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The following describes the show ip bgp cluster-list command shown in the following example.
Field Description
Network Displays the destination network prex of each BGP route.
Next Hop Displays the next hop address of the BGP router. If 0.0.0.0 is listed in this column, then
local routes exist in the routing table.
Metric Displays the BGP route’s metric, if assigned.
LocPrf Displays the BGP LOCAL_PREF attribute for the route.
Weight Displays the route’s weight.
Path Lists all the ASs the route passed through to reach the destination network.
Example
Dell#show ip bgp cluster-list
BGP table version is 64444683, local router ID is 120.1.1.1
Status codes: s suppressed, d damped, h history, * valid, > best
Path source: I - internal, a - aggregate, c - confed-external, r -
redistributed, n
- network
Origin codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPrf Weight Path
* I 10.10.10.1/32 192.68.16.1 0 100 0 i
* I 192.68.16.1 0 100 0 i
*>I 192.68.16.1 0 100 0 i
* I 192.68.16.1 0 100 0 i
* I 192.68.16.1 0 100 0 i
* I 192.68.16.1 0 100 0 i
* I 10.19.75.5/32 192.68.16.1 0 100 0 ?
* I 192.68.16.1 0 100 0 ?
*>I 192.68.16.1 0 100 0 ?
* I 192.68.16.1 0 100 0 ?
Border Gateway Protocol IPv4 (BGPv4) 343