Users Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
In the system best path selection process, the path with the highest weight value is preferred.
NOTE: In the system best-path selection process, the path with the highest weight value is preferred.
If you congure the set weight command in a route map applied to this neighbor, the weight set in that
command overrides the weight set in the neighbor weight command.
network
Specify the networks for the BGP process and enter them in the BGP routing table.
Syntax
network ip-address mask [route-map map-name]
To remove a network, use the no network ip-address mask [route-map map-name] command.
Parameters
ip-address Enter an IP address in dotted decimal format of the network.
mask
Enter the mask of the IP address in the slash prex length format (for example, /24).
The mask appears in command outputs in dotted decimal format (A.B.C.D).
route-map map-
name
(OPTIONAL) Enter the keyword route-map then the name of an established route map.
Only the following ROUTE-MAP mode commands are supported:
• match ip address
• set metric
• set tag
If the route map is not congured, the default is deny (to drop all routes).
Defaults Not congured.
Command Modes ROUTER BGP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The system software resolves the network address the network command congures with the routes in the main
routing table to ensure that the networks are reachable using non-BGP routes and non-default routes.
Related Commands redistribute — redistributes routes into BGP.
Border Gateway Protocol IPv4 (BGPv4) 333