Users Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Timer values congured with the neighbor timers command override the timer values congured with any
other command.
When two neighbors, congured with dierent keepalive and holdtime values, negotiate for new values, the
resulting values are as follows:
• the lower of the holdtime value is the new holdtime value, and
• whichever is the lower value; one-third of the new holdtime value, or the congured keepalive value, is
the new keepalive value.
neighbor timers extended
Set idle hold time for a BGP neighbor or a peer group.
Syntax
neighbor {ip-address | ipv6-address | peer-group-name} timers extended idle
holdtime
To return to the default values, use the no neighbor {ip-address | ipv6-address | peer-group-
name} timers extended idle holdtime command.
Parameters
ip-address Enter the IP address of the peer router in dotted decimal format.
ipv6-address Enter the IPv6 address of the peer router in X:X:X:X::X format.
peer-group-name Enter the name of the peer group to set the timers for all routers within the peer group.
timers extended idle
holdtime
Enter a number for the time interval, in seconds, for the peer to be idle state. The range is
from 1 to 32767. The default is 15 seconds.
Defaults
The default idle holdtime is 15 seconds.
Command Modes ROUTER BGP
Supported Modes Full–Switch
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Introduced on the C9010, MXL, FN IOM, S3100 series, S3048–ON, S4048–ON, S4048T-
ON, S5048F-ON, S6000, S6010–ON, S6100–ON, Z9100–ON, and S6000–ON.
Usage Information
The peer remains in idle state based on the congured idle holdtime. The less the idle holdtime, less
the peer in idle state.
Border Gateway Protocol IPv4 (BGPv4) 331