Users Guide

neighbor activate
This command allows the specied neighbor/peer group to be enabled for the current AFI/SAFI (Address Family Identier/Subsequent
Address Family Identier).
Syntax
neighbor [ip-address | peer-group-name] activate
To disable, use the no neighbor [ip-address | peer-group-name] activate command.
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted decimal format.
peer-group-name (OPTIONAL) Enter the name of the peer group.
activate Enter the keyword activate to enable the neighbor/peer group in the new AFI/SAFI.
Defaults Disabled
Command Modes CONFIGURATION-ROUTER-BGP-ADDRESS FAMILY
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information By default, when you create a neighbor/peer group conguration in the Router BGP context, this enables IPv4/
Unicast AFI/SAFI. When you use activate in the new context, the neighbor/peer group enables for AFI/SAFI.
neighbor add-path
This command allows the specied neighbor/peer group to send/receive multiple path advertisements.
Syntax
neighbor [ip-address | peer-group-name] add-path [send | receive | both] count
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted decimal format.
peer-group-name (OPTIONAL) Enter the name of the peer group.
send Enter the keyword send to indicate that the system sends multiple paths to peers.
receive Enter the keyword receive to indicate that the system accepts multiple paths from
peers.
both Enter the keyword both to indicate that the system sends and accepts multiple paths
from peers.
count Enter the number paths supported. The range is from 2 to 64.
Defaults none
Command Modes CONFIGURATION-ROUTER-BGP-ADDRESS FAMILY
Supported Modes Full–Switch
316 Border Gateway Protocol IPv4 (BGPv4)