Users Guide

destination Enter the IP address of the network or host to which the packets are sent.
mask Enter a network mask in /prex format (/x) or A.B.C.D. The mask, when specied in
A.B.C.D format, may be either contiguous or non-contiguous.
count (OPTIONAL) Enter the keyword count to count packets the lter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the lter processes.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry.
The range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower-
order numbers have a higher priority). If you do not use the keyword order, the ACLs
have the lowest order by default (
255).
fragments Enter the keyword fragments to use ACLs to control packet fragments.
log (OPTIONAL) Enter the keyword log to enable the triggering of ACL log messages.
threshold-in msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to indicate
the maximum number of ACL logs that can be generated, exceeding which the generation
of ACL logs is terminated with the seq, permit, or deny commands. The threshold
range is from 1 to 100.
interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes at
which ACL logs must be generated. The threshold range is from 1 to 10 minutes.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the trac that you
want to monitor and the ACL in which you are creating the rule is applied to the
monitored interface.
Defaults
By default, 10 ACL logs are generated if you do not specify the threshold explicitly. The default frequency at which
ACL logs are generated is ve minutes. By default, ow-based monitoring is not enabled.
Command Modes CONFIGURATION-IP ACCESS-LIST-EXTENDED
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Added support for ow-based monitoring on the MXL 10/40GbE Switch IO Module
platform.
9.3(0.0) Added support for logging of ACLs on the MXL 10/40GbE Switch IO Module platform.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module platform.
Usage Information
The order option is relevant in the context of the Policy QoS feature only. For more information, refer to the
“Quality of Service” chapter of the Dell Networking OS Conguration Guide.
The switch cannot count both packets and bytes, so when you enter the count byte options, only bytes are
incremented.
Most ACL rules require one entry in the CAM. However, rules with TCP and UDP port operators (for example, gt,
lt, or range) may require more than one entry. The range of ports is congured in the CAM based on bit mask
boundaries; the space required depends on exactly what ports are included in the range.
256 Access Control Lists (ACL)