Users Guide

• 25 = SMTP
• 169 = SNMP
destination Enter the IP address of the network or host to which the packets are sent.
count (OPTIONAL) Enter the keyword count to count packets the lter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the lter processes.
dscp (OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP values.
order (OPTIONAL) Enter the keyword order to specify the QoS order for the ACL entry. The
range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower-order
numbers have a higher priority). If you do not use the keyword order, the ACLs have the
lowest order by default (
255).
fragments Enter the keyword fragments to use ACLs to control packet fragments.
log (OPTIONAL) Enter the keyword log to enable the triggering of ACL log messages.
threshold-in msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to indicate
the maximum number of ACL logs that can be generated, exceeding which the generation
of ACL logs is terminated with the seq, permit, or deny commands. The threshold
range is from 1 to 100.
interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes at
which the ACL logs must be generated. The interval range is from 1 to 10 minutes.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the trac that you
want to monitor and the ACL in which you are creating the rule is applied to the
monitored interface.
Defaults By default 10 ACL logs are generated if you do not specify the threshold explicitly. The default frequency at which
the ACL logs are generated is ve minutes. By default, the ow-based monitoring is not enabled.
Command Modes CONFIGURATION-IP ACCESS-LIST-EXTENDED
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Added support for the ow-based monitoring on the MXL 10/40GbE Switch IO Module.
9.3(0.0) Added support for logging of ACLs on the MXL 10/40GbE Switch IO Module.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The order option is relevant in the context of the Policy QoS feature only. The following applies:
• The seq sequence-number command is applicable only in an ACL group.
• The order option works across ACL groups that have been applied on an interface via the QoS policy
framework.
• The order option takes precedence over seq sequence-number.
• If sequence-number is not congured, the rules with the same order value are ordered according to their
conguration order.
• If sequence-number is congured, the sequence-number is used as a tie breaker for rules with the same
order.
Access Control Lists (ACL) 181