Users Guide

The switch supports both Ingress and Egress IP ACLs.
NOTE: Also refer to the Commands Common to all ACL Types and Common IP ACL Commands sections.
ip access-list standard
Create a standard IP access list (IP ACL) to lter based on IP address.
Syntax
ip access-list standard access-list-name
Parameters
access-list-name Enter a string up to 140 characters long as the ACL name.
Defaults All IP access lists contain an implicit deny any, that is, if no match occurs, the packet is dropped.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The Dell operating system supports one ingress and one egress IP ACL per interface.
The number of entries allowed per ACL is hardware-dependent. For detailed specications on entries allowed per
ACL, refer to your line card documentation.
Example
Dell(conf)#ip access-list standard TestList
Dell(config-std-nacl)#
Related Commands
ip access-list extended — creates an extended access list.
resequence access-list — Displays the current conguration.
permit (for Standard IP ACLs)
To permit packets from a specic source IP address to leave the switch, congure a lter.
Syntax
permit {source [mask]| any | host ip-address} [no-drop] [count [byte]] [dscp
value] [order] [fragments] [log [interval minutes] [threshold-in-msgs [count]]
[monitor]
To remove this lter, you have two choices:
• Use the no seq sequence-number command if you know the lter’s sequence number.
•
Use the no permit {source [mask] | any | host ip-address} command.
Parameters
source Enter the IP address in dotted decimal format of the network from which the packet was
sent.
Access Control Lists (ACL) 159