Users Guide

• oine stack-unit
• show diag
Hardware Commands
These commands display information from a hardware sub-component or ASIC.
The hardware commands are:
• clear hardware stack-unit
• show diag
• show hardware stack-unit
• show hardware system-ow
clear hardware stack-unit
Clear statistics from selected hardware components.
Syntax
clear hardware stack-unit 0–5 {counters | unit 0–1 counters | cpu data-plane
statistics | stack-port 9–12}
Parameters
stack-unit 0–5 Enter the keywords stack-unit then 0 to 5 to select a particular stack member and
then enter one of the following command options to clear a specic collection of data.
counters Enter the keyword counters to clear the counters on the selected stack member.
unit 0–0 counters Enter the keyword unit along with a port-pipe number, from 0 to 1 , then the keyword
counters to clear the counters on the selected port-pipe.
cpu data-plane
statistics
Enter the keywords cpu data-plane statistics to clear the data plane statistics.
stack-port 9–12 Enter the keywords stack-port then the port number of the stacking port to clear the
statistics of the particular stacking port. The range is from 9 to 12.
NOTE: You can identify stack port numbers by physical inspection of the rear
modules. The numbering is the same as for the 10G ports. You can also inspect
the output of the show system stack-ports command.
Defaults none
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
Related Commands show diag — displays the data plane or management plane input and output statistics of the designated
component of the designated stack member.
1410 Debugging and Diagnostics