Users Guide

Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information To enable VRRP trac, assign an IP address to the VRRP group using the virtual-address command and
enter no disable.
Related Commands virtual-address — species the IP address of the virtual router.
hold-time
Specify a delay (in seconds) before a switch becomes the MASTER virtual router. By delaying the initialization of the VRRP MASTER, the
new switch can stabilize its routing tables.
Syntax
hold-time {seconds | centisecs centisecs}
To return to the default value, use the no hold-time command.
Parameters
seconds Enter a number of seconds. The range is from 0 to 65535. The default is zero (0)
seconds.
centisecs centisecs Enter the keyword centisecs then the number of centisecs in units of 25 centisecs.
The range is from 0 to 65525 in units of 25 centisecs.
Defaults zero (0) seconds
Command Modes VRRP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.5(0.0) Introduced the support for centisecs on the MXL 10/40GbE Switch.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information If a switch is a MASTER and you change the hold timer, disable and re-enable VRRP for the new hold timer value
to take eect.
Related Commands disable — disables a VRRP group.
preempt
To preempt or become the MASTER router, permit a BACKUP router with a higher priority value.
Syntax
preempt
To prohibit preemption, use the no preempt command.
Defaults Enabled (that is, a BACKUP router can preempt the MASTER router).
Command Modes VRRP
Supported Modes Full–Switch
1380 Virtual Router Redundancy Protocol (VRRP)