Users Guide

Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information You must rst enable DEI for this conguration to take eect.
Related Commands dei enable — enables DEI.
member
Assign a stackable VLAN access or trunk port to a VLAN. The VLAN must contain the vlan-stack compatible command in its
conguration.
Syntax
member interface
To remove an interface from a Stackable VLAN, use the no member interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
Defaults Not congured.
Command Modes conf-if-vl-<vlan-id>-stack
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information You must enable the stackable VLAN (using the vlan-stack compatible command) on the VLAN prior to
adding a member to the VLAN.
Related Commands vlan-stack compatible — enables stackable VLAN on a VLAN.
show interface dei-honor
Display the dei honor conguration.
Syntax
show interface dei-honor [interface slot/port]
Parameters
interface slot/port Enter the interface type then the line card slot and port number.
VLAN Stacking 1353