Users Guide

u-Boot

All commands in this chapter are in u-Boot mode. These commands are supported on the Dell Networking Operating System (OS) FN IOM

platform.

To access this mode, press any key when the following line appears on the console during a system boot.

Hit any key to stop autoboot:

Enter u-Boot immediately, as the BOOT_USER# prompt.

NOTE: This chapter describes only a few commands available in u-Boot mode.

NOTE: You cannot use the Tab key to complete commands in this mode.

Topics:

• boot change

• boot selection

• boot show net cong retries

• boot write net cong retries

• boot zero

• default gateway

• enable

• help

• ignore enable password

• ignore startup cong

• interface management ethernet ip address

• no default-gateway

• no interface management ethernet ip address

• reload

• show boot blc

• show boot selection

• show bootash

• show bootvar

• show default-gateway

• show interface management Ethernet

• show interface management port cong

• syntax help

boot change

Change the operating system boot parameters.

Syntax

boot change [primary | secondary | default]

1332 u-Boot