Users Guide

Version Description
9.14(0.0) Introduced on the C9010, FN–IOM, MIOA, MXL, S3048–ON, S4048–ON, S4048T–ON,
S5048F–ON, S6000, S6000–ON, S6010–ON, S6100–ON, and Z9100–ON.
Usage Information
NTP control key is not congured by default. If the encryption–type (0 or 7) is not specied, then 0 is selected by
default.
Related Commands
• ntp authentication-key—sets an authentication key for NTP.
• ntp authenticate—enables the NTP authentication parameters that you set.
• ntp server—congures an NTP time-serving host.
ntp master <stratum>
Congure the switch as NTP Server.
Syntax
ntp master <stratum>
Parameters
ntp
master<stratum>
Enter the keyword stratum number to identify the NTP Server's hierarchy. The
stratum range value is from 2 to 15 and the default value is 8.
Defaults Not congured.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the FN IOM.
9.6(0.0) Introduced on the MXL.
ntp server
Congure an NTP time-serving host.
Syntax
ntp server[vrf vrf-name] {hostname | ipv4-address | ipv6-address} [key keyid]
[prefer] [version number] [minpoll] [maxpoll]
Parameters
vrf vrf-name (Optional) Enter the keyword vrf and then the name of the VRF to congure a NTP
time-serving host corresponding to that VRF.
ipv4-address | ipv6-
address
Enter an IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X) of NTP server.
hostname Enter the hostname of the server.
1318 System Time