Users Guide

hello-time — changes the time interval between BPDUs.
portfast bpdulter default
Enable BPDU Filter globally to lter transmission of BPDU on port fast enabled interfaces.
Syntax
portfast bpdufilter default
To disable global bpdu lter default, use the no edge-port bpdufilter default command.
Defaults Disabled
Command Modes SPANNING TREE
Command History
Version Description
9.9(0.0) Introduced on the FN MXL.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
protocol spanning-tree
To enable and congure the spanning tree group, enter SPANNING TREE mode.
Syntax
protocol spanning-tree stp-id
To disable the Spanning Tree group, use the no protocol spanning-tree stp-id command.
Parameters
stp-id Enter zero (0). The system supports one spanning tree group, group 0.
Defaults Not congured.
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information STP is not enabled when you enter SPANNING TREE mode. To enable STP globally on the switch, use the no
disable command from SPANNING TREE mode.
Example
Dell(conf)#protocol spanning-tree 0
Dell(config-stp)#
Related Commands disable — disables spanning tree group 0. To enable spanning tree group 0, use the no disable command.
1306 Spanning Tree Protocol (STP)