Users Guide

To disable broadcast storm control on the interface, use the no storm-control broadcast
[packets_per_second in] command.
Parameters
packets_per_secon
d
Enter the packets per second of broadcast trac allowed into the network. The range is
from 0 to 33554368.
Defaults none
Command Modes INTERFACE (conf-if-interface-slot/port)
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
storm-control multicast (Conguration)
Congure the packets per second (pps) of multicast trac.
Syntax
storm-control multicast packets_per_second in
To disable storm-control for multicast trac into the network, use the no storm-control multicast
packets_per_second in command.
Parameters
packets_per_secon
d
Enter the packets per second of multicast trac allowed into the network. The range is
from 0 to 33554368.
Defaults none
Command Modes CONFIGURATION (conf)
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Broadcast trac (all 0xFs) should be counted against the broadcast storm control meter, not against the multicast
storm control meter. It is possible, however, that some multicast control trac may get dropped when storm
control thresholds are exceeded.
storm-control PFC/LLFC
Shut down the port if it receives the PFC/LLFC frames more than the congured rate.
Syntax
storm-control pfc-llfc [pps]in shutdown
1276 Storm Control