Users Guide

Usage Information
When you enable logging synchronous, unsolicited messages appear between software prompts and
outputs. Only the messages with a severity at or below the set level are sent to the console.
If the message queue limit is reached on a terminal line and messages are discarded, a system message appears on
that terminal line. Messages may continue to appear on other terminal lines.
Related Commands
logging on — enables logging.
logging trap
Specify which messages are logged to the Syslog server based the message severity.
Syntax
logging trap [level]
To return to the default values, use the default logging trap command.
To disable logging, use the no logging trap command.
Parameters
level Indicate a value from 0 to 7 or enter one of the following parameters: emergencies,
alerts, critical, errors, warnings, notifications, informational, or
debugging. The default is 6 or informational.
Defaults 6 or informational
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands
logging — enables the logging to another device.
logging on — enables logging.
logging version
Displays syslog messages in a RFC 3164 or RFC 5424 format.
Syntax
logging version {0|1}
Defaults
0
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
Simple Network Management Protocol (SNMP) and Syslog 1255