Users Guide

of the three sub-options as a sub-option, and so forth. The second Example shows the creation of a standard IPv4
ACL called snmp-ro-acl and then assigning it to the SNMP community guest.
NOTE: For IPv6 ACLs, only IPv6 and UDP types are valid for SNMP; TCP and ICMP rules are not valid
for SNMP. In IPv6 ACLs, port rules are not valid for SNMP.
Example
Dell#config
Dell(conf)# snmp-server community public ro
Dell(conf)# snmp-server community guest ro security-name guestuser
Dell(conf)#
Example
Dell(conf)# ip access-list standard snmp-ro-acl
Dell(config-std-nacl)#seq 5 permit host 10.10.10.224
Dell(config-std-nacl)#seq 10 deny any count
!
Dell(conf)#snmp-server community guest ro snmp-ro-acl
Dell(conf)#
Related Commands
ip access-list standard — names (or selects) a standard access list to lter based on IP address.
show running-cong — displays the current SNMP conguration and defaults.
snmp-server contact
Congure contact information for troubleshooting this SNMP node.
Syntax
snmp-server contact text
To delete the SNMP server contact information, use the no snmp-server contact command.
Parameters
text Enter an alphanumeric text string, up to 55 characters long.
Defaults none
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
snmp-server enable traps
Enable SNMP traps.
Syntax
snmp-server enable traps [notification-type] [notification-option]
To disable traps, use the no snmp-server enable traps [notification-type] [notification-
option] command.
1234 Simple Network Management Protocol (SNMP) and Syslog