Users Guide

sow enable (Global)
Enable sFlow globally.
Syntax
sflow enable
To disable sFlow, use the no sflow enable command.
Defaults Disabled.
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information sFlow is disabled by default. In addition to this command, you must enable sFlow on individual interfaces where you
want sFlow sampling.
Related Commands sow enable (Global) — enables sFlow on interfaces.
sow ingress-enable
Enable sFlow ingress on interfaces.
Syntax
sflow ingress-enable
To disable sFlow, use the no sflow ingress enable command.
Defaults Disabled.
Command Modes INTERFACE
Supported Modes Full–Switch Mode
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Introduced on the MXL switch.
Usage Information When you enable ingress sFlow on an interface, ow sampling is done on any incoming trac.
NOTE: After a physical port is a member of a LAG, it inherits the sFlow conguration from the LAG port.
Related Commands sow enable (Global) — turns sFlow globally.
sFlow 1215