Users Guide
Version Description
9.13(0.0) Introduced on the C9010, S3100, S3048–ON, S4048T-ON, S4048–ON, S5000, S6010–
ON, S6000–ON, S6100–ON, S6000, Z9100–ON, Z9500, FN-IOM, and MXL.
Usage Information If this conguration is not enabled, then dynamic authorization messages are not handled by the NAS.
ip radius source-interface
Specify an interface’s IP address as the source IP address for RADIUS connections.
Syntax
ip radius source-interface interface
To delete a source interface, use the no ip radius source-interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
• For a ten-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
•
For VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults Not congured.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
port
Congures NAS port number to accept CoA or DM requests.
Syntax
port port-number
To remove the NAS port conguration, enter the no port command.
Defaults 3799
Parameters
port-number Enter the NAS port number to accept CoA and DM requests. The range is from 1 to
65535.
Command Modes
• CONF-DYNAMIC-AUTH
Security 1171