Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsFN IO Module
1131113211331134113511361137113811391140
edge-port bpdulter default
To lter transmission of BPDU on port fast enabled interfaces, enable BPDU Filter globally.
Syntax
edge-port bpdufilter default
To disable global bpdu lter default, use the no edge-port bpdufilter default command.
Parameters
priority-value Enter a number as the bridge priority value in increments of 4096. The range is from 0 to
61440. The default is 32768.
Defaults Disabled
Command Modes CONFIGURATION (conf-rstp)
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
protocol spanning-tree rstp
To congure RSTP, enter RSTP mode.
Syntax
protocol spanning-tree rstp
To exit RSTP mode, use the exit command.
Defaults Not congured
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information RSTP is not enabled when you enter RSTP mode. To enable RSTP globally on the system, use the no disable
command from RSTP mode.
Example
Dell(conf)#protocol spanning-tree rstp
Dell(config-rstp)##no disable
Related Commands disable — disables RSTP globally on the system.
Rapid Spanning Tree Protocol (RSTP) 1133