Users Guide

holddown Enter the number of seconds to specify a time interval during which the route is marked
as unreachable but still sending RIP packets. The holddown value should be at least three
times the update timer value. The range is from zero (0) to 4294967295. The default is
180 seconds.
ush Enter the number of seconds to specify the time interval during which the route is
advertised as unreachable. When this interval expires, the route is ushed from the
routing table. The ush value should be greater than the update value. The range is from
zero (0) to 4294967295. The default is 240 seconds.
Defaults
• update = 30 seconds
• invalid = 180 seconds
• holddown = 180 seconds
• ush = 240 seconds
Command Modes ROUTER RIP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information If you change the timers on one router, also synchronize the timers on all routers in the RIP domain.
version
Specify either RIP version 1 or RIP version 2.
Syntax
version {1 | 2}
To return to the default version setting, use the no version command.
Parameters
1 Enter the keyword 1 to specify RIP version 1.
2 Enter the keyword 2 to specify RIP version 2.
Defaults The system sends RIPv1 and receives RIPv1 and RIPv2.
Command Modes ROUTER RIP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands
ip rip receive version — sets the RIP version the interface receives.
ip rip send version — sets the RIP version the interface sends.
Routing Information Protocol (RIP) 1117