Users Guide

output-delay
Set the interpacket delay of successive packets to the same neighbor.
Syntax
output-delay delay
To return to the switch software defaults for interpacket delay, use the no output-delay command.
Parameters
delay Specify a number of milliseconds as the delay interval. The range is from 8 to 50.
Defaults Not congured.
Command Modes ROUTER RIP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information This command is intended for low-speed interfaces.
passive-interface
Suppress routing updates on a specied interface.
Syntax
passive-interface interface
To delete a passive interface, use the no passive-interface interface command.
Parameters
interface Enter the following information:
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
•
For a VLAN, enter the keyword vlan then a number from 1 to 4094.
Defaults Not congured.
Command Modes ROUTER RIP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Although the passive interface does not send or receive routing updates, the network on that interface still
includes in RIP updates sent using other interfaces.
1112 Routing Information Protocol (RIP)