Users Guide

To send sub-prex routing information, use the no auto-summary command.
Defaults Enabled.
Command Modes ROUTER RIP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
clear ip rip
Update all the RIP routes in the routing table.
Syntax
clear ip rip
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
This command triggers updates of the main RIP routing tables.
debug ip rip
Examine RIP routing information for troubleshooting.
Syntax
debug ip rip [interface | database | events [interface] | packet [interface] |
trigger]
To turn o debugging output, use the no debug ip rip command.
Parameters
interface (OPTIONAL) Enter the interface type and ID as one of the following:
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
•
For a VLAN, enter the keyword vlan then a number from 1 to 4094.
database (OPTIONAL) Enter the keyword database to display messages when there is a change
to the RIP database.
events (OPTIONAL) Enter the keyword events to debug only RIP protocol changes.
Routing Information Protocol (RIP) 1103