Users Guide
Version Description
9.11(0.0) Introduced GRE protocol support.
Related Commands
• monitor session — creates a session for monitoring trac with port monitoring.
• show monitor session — displays information about monitor congurations.
ow-based enable
Enable ow-based monitoring.
Syntax
flow-based enable
To disable ow-based monitoring, use the no flow-based enable command.
Defaults Disabled, that is ow-based monitoring is not applied.
Command Modes MONITOR SESSION (conf-mon-sess-session-ID)
Supported Modes Full—Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Added support for the RPM/ERPM.
9.3(0.0) Introduced on the MXL 10/40GbE Switch IO Module platform.
8.1.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced on the E-Series.
Usage Information To monitor trac with particular ows the interface, appropriate ACLs has be applied in ingress direction. Flow-
based is not supported in the tx direction. Even though we can congure it in both the direction, only rx will work.
The ow- based enable command has to be applied as a monitor session with some conguration which is already
present in it, other wise ow- based will not take eect.
Related Commands
monitor session – enables a monitoring session.
rate-limit
Congure the rate-limit to limit the mirrored packets.
Syntax
rate-limit limit
To remove the limit, use the no rate-limit limit command.
Parameters
limit Enter the rate-limit value. The range is from 0 to 40000 Megabits per second.
Defaults 60
Command Modes CONFIGURATION
Port Monitoring 1037