Users Guide

0/0 register messages sent/received
Memory usage:
TIB : 3768 bytes
Nexthop cache : 0 bytes
Interface table : 992 bytes
Neighbor table : 528 bytes
RP Mapping : 0 bytes
show ip pim tib
View the PIM tree information base (TIB).
Syntax
show ip pim tib [group-address [source-address]]
Parameters
group-address (OPTIONAL) Enter the group address in dotted decimal format (A.B.C.D).
source-address (OPTIONAL) Enter the source address in dotted decimal format (A.B.C.D).
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full—Swtich
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show ip pim tib command shown in the following example.
Field Description
(S, G) Displays the entry in the multicast PIM database.
uptime Displays the amount of time the entry has been in the PIM route table.
expires Displays the amount of time until the entry expires and is removed from the database.
RP Displays the IP address of the RP/source for this entry.
ags List the ags to dene the entries:
• D = PIM Dense Mode
• S = PIM Sparse Mode
• C = directly connected
• L = local to the multicast group
• P = route was pruned
• R = the forwarding entry is pointing toward the RP
• F = Dell Networking OS is registering this entry for a multicast source
• T = packets were received via Shortest Tree Path
• J = rst packet from the last hop router is received and the entry is ready to switch to
SPT
• K = acknowledge pending state
PIM-Sparse Mode (PIM-SM) 1023