Deployment Guide
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information If you use this command on a local VLT node, all multicast routes from the local PIM TIB, the entire multicast route
table, and all the entries in the data plane are deleted. The local VLT node sends a request to the peer VLT node to
download multicast routes learned by the peer. Both local and synced routes are removed from the local VLT node
multicast route table. The peer VLT node clears synced routes from the node.
If you use this command on a peer VLT node, only the synced routes are deleted from the multicast route table.
debug ip pim
View IP PIM debugging messages.
Syntax
debug ip pim [bsr | events | group | packet [in | out] | register | state |
timer [assert | hello | joinprune | register]]
To disable PIM debugging, use the no debug ip pim command or use the undebug all to disable all the
debugging commands.
Parameters
bsr (OPTIONAL) Enter the keyword bsr to view PIM Candidate RP/BSR activities.
events (OPTIONAL) Enter the keyword group to view PIM messages for a specic group.
group (OPTIONAL) Enter the keyword group to view PIM messages for a specic group.
packet [in | out] (OPTIONAL) Enter the keyword packet to view PIM packets. Enter one of the optional
parameters:
• in: to view incoming packets
• out: to view outgoing packets
register (OPTIONAL) Enter the keyword register to view PIM register address in dotted
decimal format (A.B.C.D).
state (OPTIONAL) Enter the keyword state to view PIM state changes.
timer [assert | hello
| joinprune |
register]
(OPTIONAL) Enter the keyword timer to view PIM timers. Enter one of the optional
parameters:
• assert: to view the assertion timer
• hello: to view the PIM neighbor keepalive timer
• joinprune: to view the expiry timer (join/prune timer)
• register: to view the register suppression timer
Defaults Disabled.
Command Modes EXEC Privilege
Supported Modes Full—Swtich
994 PIM-Sparse Mode (PIM-SM)