Deployment Guide

ip telnet server enable

Enable the Telnet server on the switch.

Syntax

ip telnet server enable

To disable the Telnet server, use the no ip telnet server enable command.

Defaults Enabled

Command Modes CONFIGURATION

Supported Modes All Modes

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.4(0.0) Supported on the FN I/O Aggregator.

8.3.17.0 Supported on the M I/O Aggregator.

ip telnet source-interface

Set an interface’s IP address as the source address in outgoing packets for Telnet sessions.

Syntax

ip telnet source-interface interface

Parameters

interface Enter the following keyword and slot/port or number information:

• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet

followed by the slot/port information.

• For VLAN interface, enter the keyword vlan then a number from 1 to 4094.

Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets.