Deployment Guide

Command Modes ROUTER OSPF
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(conf-router_ospf)#show config
!
router ospf 3
passive-interface FastEthernet 0/1
Dell(conf-router_ospf)#
show ip ospf
Display information on the OSPF process congured on the switch.
Syntax
show ip ospf process-id
Parameters
process-id Enter the OSPF Process ID to show a specic process. If no Process ID is entered,
command applies only to the rst OSPF process.
Command Modes
EXEC
EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information If you delete all the network area commands for Area 0, the show ip ospf command output does not list Area
0.
The following describes the show ip ospf command shown in the following example.
Line Beginning
with
Description
“Routing Process... Displays the OSPF process ID and the IP address associated with the process ID.
“Supports only... Displays the number of Type of Service (TOS) rouse supported.
“SPF schedule... Displays the delay and hold time congured for this process ID.
“Convergence
Level”
“Min LSA.... Displays the intervals set for LSA transmission and acceptance.
934 Open Shortest Path First (OSPFv2 and OSPFv3)