Deployment Guide

mib-binding

Enable this OSPF process ID to manage the SNMP traps and process SNMP queries.

Syntax

mib-binding

To mib-binding on this OSPF process, use the no mib-binding command.

Defaults none.

Command Modes ROUTER OSPF

Supported Modes Full–Switch

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

This command is either enabled or disabled. If no OSPF process is identied as the MIB manager, the rst OSPF

process is used.

If an OSPF process has been selected, it must be disabled prior to assigning new process ID the MIB responsibility.

network area

Dene which interfaces run OSPF and the OSPF area for those interfaces.

Syntax

network ip-address mask area area-id

To disable an OSPF area, use the no network ip-address mask area area-id command.

Parameters

ip-address Specify a primary or secondary address in dotted decimal format. The primary address is

required before adding the secondary address.

mask Enter a network mask in /prex format. (/x)

area-id Enter the OSPF area ID as either a decimal value or in a valid IP address. Decimal value

range is from 0 to 65535. IP address format is dotted decimal format A.B.C.D.

NOTE: If the area ID is smaller than 65535, it is converted to a decimal value.