Deployment Guide

Parameters
level (OPTIONAL) Enter a number for a privilege level of the Dell Networking OS. The range is
from 0 to 15. The default is 1.
Defaults 1
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
do
Allows the execution of most EXEC-level commands from all CONFIGURATION levels without returning to the EXEC level.
Syntax
do command
Parameters
command Enter an EXEC-level command.
Defaults none
Command Modes
• CONFIGURATION
• INTERFACE
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following commands are not supported by the do command:
• enable
• disable
• exit
• config
Example
Dell(conf-if-te-3/1)#do clear counters
Clear counters on all interfaces [confirm]
Dell(conf-if-te-3/1)#
Dell(conf-if-te-3/1)#do clear logging
Clear logging buffer [confirm]
Dell(conf-if-te-3/1)#
Dell(conf-if-te-3/1)#do reload
System configuration has been modified. Save? [yes/no]: n
Proceed with reload [confirm yes/no]: n
Dell(conf-if-te-3/1)#
88 Control and Monitoring