Deployment Guide
Multicast
The multicast commands are supported by Dell Networking Operating System (OS).
This chapter contains the following sections:
• IPv4 Multicast Commands
• IPv6 Multicast Commands
Topics:
• IPv4 Multicast Commands
• clear ip mroute
• ip mroute
• ip multicast-limit
• ip multicast-routing
• mtrace
• show ip mroute
• show ip rpf
• IPv6 Multicast Commands
• debug ipv6 mld_host
• ip multicast-limit
IPv4 Multicast Commands
The following section contains the IPv4 multicast commands.
clear ip mroute
Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent multicast (PIM) tree information base,
use the clear ip pim tib command.
Syntax
clear ip mroute {group-address [source-address] | * | snooping}
Parameters
group-address
[source-address]
Enter the multicast group address and source address (if desired), in dotted decimal
format, to clear information on a specic group.
* Enter * to clear all multicast routes.
snooping Enter the keyword snooping to delete multicast snooping route table entries.
Command Modes EXEC Privilege
Supported Modes Full–Switch
39
Multicast 879