Deployment Guide

Defaults Disabled.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
This command turns on BGP soft-reconguration inbound debugging for IPv6 unicast routes. If no neighbor is
specied, debug is turned on for all neighbors.
Related Commands show ip bgp ipv6 unicast dampened-paths — views BGP dampened routes.
debug ip bgp keepalives
Allows you to view information about BGP keepalive messages.
Syntax
debug ip bgp [ipv6-address | peer-group peer-group-name] keepalives [in | out]
To disable debugging, use the no debug ip bgp [ip-address | peer-group peer-group-name]
keepalives [in | out] command.
Parameters
ipv6-address (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format then the prex length in
the /x format. The range is /0 to /128.
NOTE: The :: notation species successive hexadecimal elds of zeros.
peer-group peer-
group-name
(OPTIONAL) Enter the keywords peer-group then the name of the peer group.
in (OPTIONAL) Enter the keyword in to view only inbound keepalive messages.
out (OPTIONAL) Enter the keyword out to view only outbound keepalive messages.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Entering a no debug ip bgp command removes all congured debug commands for BGP.
IPv6 Border Gateway Protocol (IPv6 BGP) 685