Deployment Guide

show ipv6 mld_host
Display the IPv6 MLD host counters.
Syntax
show ipv6 mld_host
Command Modes EXEC
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show ipv6 mld-host command shown in the following example.
Field Description
Valid MLD Packets The total number of packets received and sent from the last time the elapsed time was
cleared.
Reports The total number of reports (queries and unsolicited reports generated from joins or
leaves) that have been received or sent.
Leaves The number of Multicast leaves that have been sent.
MLDv1 queries The number of MLDv1 queries that have been received.
MLDv2 queries The number of MLDv2 queries that have been received.
Malformed Packets The number of MLDv1 and MLDv2 packets that do not match the requirement for a valid
MLD packet.
Example
MLD Host Traffic Counters
Elapsed time since counters cleared: 0028:33:52
Received Sent
Valid MLD Packets 97962 18036
Reports 79962 18034
Leaves ---- 0
MLDv2 Queries 18000 ----
MLDv1 Queries 0 ----
Errors:
Malformed Packets: 4510
show ipv6 route
Displays the IPv6 routes.
Syntax
show ipv6 route [ipv6-address prefix-length] [hostname] [all] [bgp as number]
[connected] [isis tag] [list prefix-list name] [ospf process-id] [rip] [static]
[summary]
Parameters
ipv6-address prex-
length
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format then the prex length in
the /x format. The range is from /0 to /128.
660 IPv6 Basics