Deployment Guide

Total 1388 active route(s) using 222440 bytes
Total 2 non-active route(s) using 128 bytes
Dell>
Related Commands
show ip route — displays information about the routes found in the switch.
show ip trac
View IP, ICMP, UDP, TCP and ARP trac statistics.
Syntax
show ip traffic
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show ip traffic summary shown in the following example.
Keyword Denition
unknown protocol... No receiver for these packets. Counts packets whose protocol type eld is not recognized
by the system.
not a gateway... Packets can not be routed; the host/network is unreachable.
security failures... Counts the number of received unicast/multicast packets that could not be forwarded
due to:
• route not found for unicast/multicast; ingress interfaces do not belong to the
destination multicast group
• destination IP address belongs to reserved prexes; the host/network is unreachable
bad options... Unrecognized IP option on a received packet.
Frags: IP fragments received.
... reassembled Number of IP fragments that were reassembled.
... timeouts Number of times a timer expired on a reassembled queue.
... too big Number of invalid IP fragments received.
... couldn’t fragment Number of packets that could not be fragmented and forwarded.
...encapsulation
failed
Counts packets which could not be forwarded due to ARP resolution failure. The system
sends an arp request prior to forwarding an IP packet. If a reply is not received, the
system repeats the request three times. These packets are counted in encapsulation
failed.
Rcvd:
...short packets The number of bytes in the packet are too small.
...bad length The length of the packet was not correct.
626 IPv4 Routing