Deployment Guide

When rate interval is congured in both global conguration mode as well as interface mode, then the rate-interval
value congured at interface level is applied as it takes precedence over the global value.
remote-fault-signaling rx
Brings the interface up or down when a Remote Fault Indication (RFI) error is detected.
Syntax
remote-fault-signaling rx {on | off}
Parameters
on Brings the interface up when an RFI error is detected.
o Brings the interface down when an RFI error is detected.
Defaults ON.
Command Modes INTERFACE CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Introduced on the MXL switch.
Usage Information
By default, the switch processes the RFI errors transmitted by remote peers and brings down the interface when
an RFI error is detected.
Example
Dell(conf-if-te-1/3)#remote-fault-signaling rx ?
on Enable
off Disable
show cong
Display the interface conguration.
Syntax
show config
Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(conf-if)#show conf
!
interface TenGigabitEthernet 1/7
no ip address
switchport
Interfaces 549