Deployment Guide

9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information This command places you into the resilient ring protocol. After executing this command, the command line prompt
changes to conf-frrp.
show frrp
Display the resilient ring protocol conguration.
Syntax
show frrp [ring-id [summary]] | [summary]
Parameters
ring-id Enter the ring identication number. The range is from 1 to 255
summary (OPTIONAL) Enter the keyword summary to view just a summarized version of the Ring
conguration.
Defaults none
Command Modes EXEC
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Executing this command without the optional ring-id command clears the statistics counters on all the available
rings. The system requires a command line conrmation before the command executes. This command clears the
following counters:
• hello Rx and Tx counters
• Topology change Rx and Tx counters
• The number of state change counters
Example (Summary)
Dell#show frrp summary
Ring-ID State Mode Ctrl_Vlan Member_Vlans
----------------------------------------------
2 UP Master 2 11-20, 25,27-30
31 UP Transit 31 40-41
50 Down Transit 50 32
Dell#
Example (1)
Dell#show frrp 1
Ring protocol 1 is in Master mode
Ring Protocol Interface:
Primary : TenGigabitEthernet 0/6 State: Forwarding
Secondary: Port-channel 100 State: Blocking
Control Vlan: 1
Ring protocol Timers: Hello-Interval 50 msec Dead-Interval 150 msec
Ring Master's MAC Address is 00:01:e8:13:a3:19
Topology Change Statistics: Tx:110 Rx:45
Hello Statistics: Tx:13028 Rx:12348
Number of state Changes: 34
Member Vlans: 1000-1009
Dell#
502 Force10 Resilient Ring Protocol (FRRP)