Deployment Guide
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.3(0.0) Introduced on the FC Flex IO module installed in the M I/O Aggregator.
description
Enter a text description of the DCB policy (PFC input or ETS output).
Syntax
description text
To remove the text description, use the no description command.
Parameters
text Enter the description of the output policy. The maximum is 32 characters.
Defaults none
Command Modes
• DCB INPUT POLICY
• DCB OUTPUT POLICY
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
fc-map
In an FCoE map, congure the FCoE mapped address prex (FC-MAP) value which is used to identify FCoE trac transmitted on the
FCoE VLAN for the specied fabric.
Syntax
fc—map fc-map-value
Parameters
fc-map-value Enter the unique MAC address prex used by a SAN fabric.
The range of FC-MAP values is from 0EFC00 to 0EFCFF.
Defaults None
Command Modes FCoE MAP
Supported Modes Programmable-Mux (PMUX)
Full–Switch
404 Data Center Bridging (DCB)