Deployment Guide

cam-optimization
Optimize CAM utilization for QoS Entries by minimizing require policy-map CAM space.
Syntax
cam-optimization [qos]
Parameters
qos Optimize CAM usage for QoS.
Defaults Disabled.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information When you enable this command, if a Policy Map containing classication rules (ACL and/or dscp/ ip-precedence
rules) is applied to more than one physical interface on the same port pipe, only a single copy of the policy is
written (only one FP entry is used).
NOTE: An ACL itself may still require more that a single FP entry, regardless of the number of
interfaces. For more information, refer to the IP Access Control Lists , Prex Lists , and Route-
map sections in the Dell Networking Operating System Conguration Guide .
show cam-acl
Display the details of the CAM proles on the chassis and all stack units.
Syntax
show cam-acl
Defaults none
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The display reects the settings implemented with the cam-acl command.
Example (Default)
Dell#show cam-acl
-- Chassis Cam ACL --
Current Settings(in block sizes)
1 block = 128 entries
L2Acl : 6
Ipv4Acl : 4
Ipv6Acl : 0
Ipv4Qos : 2
L2Qos : 1
374 Content Addressable Memory (CAM)