Deployment Guide

Parameters
ip-address Enter the IP address of the peer router in dotted decimal format.
peer-group-name Enter the name of the peer group to set the timers for all routers within the peer group.
keepalive Enter a number for the time interval, in seconds, between keepalive messages sent to the
neighbor routers. The range is from 1 to 65535. The default is 60 seconds.
holdtime Enter a number for the time interval, in seconds, between the last keepalive message and
declaring the router dead. The range is from 3 to 65535. The default is 180 seconds.
Defaults
• keepalive = 60 seconds
• holdtime = 180 seconds
Command Modes ROUTER BGP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Timer values congured with the neighbor timers command override the timer values congured with any
other command.
When two neighbors, congured with dierent keepalive and holdtime values, negotiate for new values, the
resulting values are as follows:
• the lower of the holdtime value is the new holdtime value, and
• whichever is the lower value; one-third of the new holdtime value, or the congured keepalive value, is
the new keepalive value.
neighbor update-source
Enable the software to use Loopback interfaces for TCP connections for BGP sessions.
Syntax
neighbor {ip-address | peer-group-name} update-source interface
To use the closest interface, use the no neighbor {ip-address | peer-group-name} update-
source interface command.
Parameters
ip-address Enter the IP address of the peer router in dotted decimal format.
peer-group-name Enter the name of the peer group to disable all routers within the peer group.
interface Enter the keyword loopback then a number of the Loopback interface. The range is
from 0 to 16383.
Defaults Not congured.
Command Modes ROUTER BGP
Supported Modes Full–Switch
Border Gateway Protocol IPv4 (BGPv4) 327