Deployment Guide

out Enter the keyword out to distribute only outbound trac.
Defaults Not congured.
Command Modes ROUTER BGP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Other BGP ltering commands include: neighbor filter-list, ip as-path access-list, and
neighbor route-map.
Related Commands
neighbor route-map — assigns a route map to a neighbor or peer group.
neighbor ebgp-multihop
Attempt and accept BGP connections to external peers on networks that are not directly connected.
Syntax
neighbor {ip-address | peer-group-name} ebgp-multihop [ttl]
To disallow and disconnect connections, use the no neighbor {ip-address | peer-group-name}
ebgp-multihop command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
ttl (OPTIONAL) Enter the number of hops as the Time to Live (ttl) value. The range is from 1
to 255. The default is 255.
Defaults Disabled.
Command Modes ROUTER BGP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information To prevent loops, the neighbor ebgp-multihop command does not install the default routes of the multihop
peer. Networks not directly connected are not considered valid for best-path selection.
neighbor fall-over
Enable or disable fast fall-over for BGP neighbors.
Syntax
neighbor {ipv4-address | peer-group-name} fall-over
316 Border Gateway Protocol IPv4 (BGPv4)