Deployment Guide

Command Modes ROUTE-MAP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands route-map — Enables a route map.
match interface
To match routes whose next hop is on the interface specied, congure a lter.
Syntax
match interface interface
To remove a match, use the no match interface interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For the Loopback interface, enter the keyword loopback then a number from zero
(0) to 16383.
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
•
For a Ten Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
Defaults Not congured.
Command Modes ROUTE-MAP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands
match ip address — redistributes routes that match an IP address.
match ip next-hop — redistributes routes that match the next-hop IP address.
match ip route-source — redistributes routes that match routes advertised by other routers.
match metric — redistributes routes that match a specic metric.
match route-type — redistributes routes that match a route type.
match tag — redistributes routes that match a specic tag.
Access Control Lists (ACL) 197