Deployment Guide

Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
show mac accounting access-list
Display MAC access list congurations and counters (if congured).
Syntax
show mac accounting access-list access-list-name interface interface in | out
Parameters
access-list-name Enter the name of a congured MAC ACL, up to 140 characters.
interface interface Enter the keyword interface then the one of the following keywords and slot/port or
number information:
• For a Port Channel interface, enter the keywords port-channel and then enter a
number. The range is from 1 to 128.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet and
then enter the slot/port information.
• For a VLAN interface enter the keyword VLAN and then the vlan id
in | out Identify whether ACL is applied on ingress or egress side.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The ACL hit counters in this command increment the counters for each matching rule, not just the rst matching
rule.
Example
Dell#show mac accounting access-list TestMac interface tengigabitethernet 0/1
in
Ingress Standard mac access-list TestMac on TenGigabitEthernet 0/1
Total cam count 2
seq 5 permit aa:aa:aa:aa:00:00 00:00:00:00:ff:ff count (0 packets)
seq 10 deny any count (20072594 packets)
Dell#
Standard MAC ACL Commands
When you create an access control list without any rule and then apply it to an interface, the ACL behavior reects implicit permit. These
commands congure standard MAC ACLs.
The switch supports both Ingress and Egress MAC ACLs.
Access Control Lists (ACL)
181