Deployment Guide

• 169 = SNMP
destination Enter the IP address of the network or host to which the packets are sent.
mask Enter a network mask in /prex format (/x) or A.B.C.D. The mask, when specied in
A.B.C.D format, may be either contiguous or non-contiguous.
count (OPTIONAL) Enter the keyword count to count packets the lter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the lter processes.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry.
The range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower-
order numbers have a higher priority) If you did not use the keyword order, the ACLs
have the lowest order by default (
255).
fragments Enter the keyword fragments to use ACLs to control packet fragments.
threshold-in-msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to indicate
the maximum number of ACL logs that can be generated, exceeding which the generation
of ACL logs is terminated with the seq, permit, or deny commands. The threshold
range is from 1 to 100.
Defaults
By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is ve minutes. By default, ow-based monitoring is not
enabled.
Command Modes CONFIGURATION-IP ACCESS-LIST-EXTENDED
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Added the support for ow-based monitoring on the MXL 10/40GbE Switch IO Module
platforms.
9.3(0.0) Added the support for logging of ACLs on the MXL 10/40GbE Switch IO Module
platforms.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The order option is relevant in the context of the Policy QoS feature only. For more information, refer to the
Quality of Service chapter of the Dell Networking OS Conguration Guide.
You can congure either count (packets) or count (bytes). However, for an ACL with multiple rules, you can
congure some ACLs with count (packets) and others as count (bytes) at any given time.
Most ACL rules require one entry in the CAM. However, rules with TCP and UDP port operators (for example, gt,
lt, or range) may require more than one entry. The range of ports is congured in the CAM based on bit mask
boundaries; the space required depends on exactly what ports are included in the range.
When the congured maximum threshold is exceeded, generation of logs is stopped. When the interval at which
ACL logs are congured to be recorded expires, the subsequent, fresh interval timer is started and the packet
count for that new interval commences from zero. If ACL logging was stopped previously because the congured
threshold is exceeded, it is re-enabled for this new interval.
164 Access Control Lists (ACL)