Deployment Guide

You must rst create a VLAN and then specify the congured VLAN ID in the fabric-id vlan command.
Otherwise, the following error message is displayed.
FTOS(conf-fcoe-f)#fabric-id 10 vlan 10 % Error: Vlan 10 does not exist
Related Commands
fcoe-map — creates an FCoE map which contains the parameters used in the communication between servers
and a SAN fabric.
show fcoe-map — displays the Fibre Channel and FCoE conguration parameters in FCoE maps.
fcf-priority
In an FCoE map, congure the priority used by a server CNA to select an upstream FCoE forwarder (FCF).
Syntax
fcf—priority priority
Parameters
priority Enter the priority assigned to the switch with the FC Flex IO module NPIV proxy gateway,
which appears to a downstream server CNA as an FCF. The range of FCF priority values
is from 1 to 255.
Defaults 128
Command Modes FCOE MAP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.3(0.0) Introduced on the M I/O Aggregator and MXL 10/40GbE Switch with the FC Flex IO
module.
Usage Information
The FCF priority you assign to the Switch with the FC Flex IO module is used by server CNAs to select an
upstream FCF to use for a fabric login (FLOGI).
To remove a congured FCF priority from an FCoE map, enter the no fcf-priority command.
Related Commands
fcoe-map — creates an FCoE map which contains the parameters used in the communication between servers
and a SAN fabric.
show fcoe-map — displays the Fibre Channel and FCoE conguration parameters in FCoE maps.
fc-map
In an FCoE map, congure the FCoE mapped address prex (FC-MAP) value which is used to identify FCoE trac transmitted on the
FCoE VLAN for the specied fabric.
Syntax
fc—map fc-map-value
Parameters
fc-map-value Enter the unique MAC address prex used by a SAN fabric.
FC Flex IO Modules 1369